Not all drain cleaners were created equal

Check out these two augers. One of them is a grease cutter that fits a 5/8 inch rod. The other is a sharktooth cutter for a 7/8 inch rod.

Most plumbers in these parts don't carry 7/8 inch rods. Normally that is ok. However, when encountering a kitchen grease clog on a 4" line that can be an issue. With the smaller cutter only a small tunnel is bored into the grease. This can result in frequent clogging.

When a properly sized cutter is used the line is properly cleaned resulting in a far longer period inbetween cleanings.

---

---